Ceiling Fan Light Remote Control Problems

The motor should be tested with special attention to the windings and the start capacitor.

Ceiling fan light remote control problems.

These troubleshooting steps will take you through the basic operation of the remote like checking the batteries and determining whether the remote is sending a signal or not. Probably causes are a faulty light kit the fuse in the light kit has blown a faulty wall or remote control which could be either the handset or receiver broken or faulty light switch or just incorrect installation. Make sure to also check that the lid at the back of the remote is firmly sealed after replacing the batteries. Screw them into.

The receiver for your remote is located within the ceiling fan housing itself. They are more likely to go over the years. Turn off the circuit breaker that provides power to the ceiling fan. Check if the batteries in the remote may need replacement even if you replaced them as recently as a week ago.

If your hampton bay ceiling fan remote is not working there are some standard troubleshooting steps you can go through in order to determine the problem. Also times you can have a defective receiver right out of the box. The dip switch settings on the remote and the ones inside of the fan must be the same or there will be problems with the fan not communicating with the remote properly. They will be located on the ceiling fan receiver inside of the fan s canopy.

Locate the receiver and identify the dip switch settings which should resemble four sliding buttons. If things look good return light bulbs that are in working order into their sockets. Tighten any loose screws on the light kit fan blades motor coupling downrod and mounting hardware. The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high.

Remove any dirt or debris from all fan blades. A lot of problems with your remote communicating with your ceiling fan are generally related to the receiver which communicates with your remote control. Look inside of the light bulb socket to make sure there are no burn marks or charred spots. So if the pull chain is in the off position the remote control will not be able to get any power to the ceiling fan light or fan.

Use the steps below to determine the cause of the problem. Use a small screwdriver. The problem may not be with the remote control but rather a component of the ceiling fan. If your ceiling fan remote is not working you may want to follow these steps to find out the cause of the problem.

3 the fan or light functions on its own accord randomly. If this is a new ceiling fan you may consider returning it to where you purchased it from and explain the situation and hopefully they will give you a replacement. If you see black or burned areas this may be a sign that your ceiling fan light kit has a wiring issue.